I found a lot of information on the Internet, I can't fully get it; the sure of myself is tune! ! Finally got it! The article is mainly for everyone to think, most cats are similar! After that, everyone will slowly try! Haha! Master-class:
1. Set the IP address in the PC network to 192.168.1.xxx network segment (my IP: 192.168.1.8), mask: 255.255.255.0; gateway: 192.168.1.1; (in online neighbor - "attribute - "Changed in TCP / IP Agreement)
2. Open the IE browser, address column entry: http: //192.168.1.1, Enter, IE pops up the following interface. (If you are not accessible, cancel all the settings for IE before, this is not to say!)
3. Enter the username and password. Most of the website introduction is admin, but I didn't succeed! !
It is generally admin, but this is not, username: admin; password: EPICRouter. If you can't find your account password, you can go to the corresponding manufacturer's homepage to download the manual!
4. After entering the main interface, you need to make a simple settings for some corresponding parameters! Here I simply talk about it.
My cat's software version is: V200R001C01B012SP01. After entering the interface, select the ATM setting, the permanent virtual connection selects PVC 0, then there will be an interface, and the virtual circuit should add Enabled, bridge and IGMP are disabled. The package selection PPPoE LLC, the VPI / VPC value is generally 0/35, Or 8/35. You can ask the local service provider! Static IP does not have to add, usernames and passwords Add you to apply for ADSL's service providers to provide you. The security agreement is generally selected by AUTO, and it is also available to ask a local service provider! Then check the automatic connection! Finally, choose submission! It can be said that this work is basically completed!
5. The other settings on the left side of the page are then click. ADSL mode selection g.dmt, then select submission! DHCP can be used by default, directly choose to submit it! DNS adds your local DNS server, if you don't add, you may not open a web page! All parameters are set up properly! NAT is also the default, directly select it, if you do FTP in the intranet, you will use NAT! However, general users can not be used, directly submit it!
6. Finally, the saves on the left side of the page will restart, and store it! Ok!
