After the collection of online data, it has finally completed the FreeBSD 4.10 Chinese configuration. Close up for your reference. 1. Install chinput3 #cd / usr / ports / chinese / chinput3 #make #make install #make clean 2. Add the following: STENV LC_ALL EN_CN.EUC STENV LANG EN_CN.EUC STENV LC_CTYPE EN_CN. Euc Stenv XModifiers @ im = chinput 3. Add the content in ~ / .xinitrc as follows: Exec chinput & exec gnome-session 4. Finally, the content of / etc / x11 / xf86config can refer to the following: section "ModulePath" / usr / X11r6 / lib / modules "fontpath" / usr / x11r6 / lib / x11 / fonts / trueType / "fontpath" / usr / x11r6 / lib / x11 / fonts / misc / "fontpath" / usr / x11r6 / lib / x11 / FONTS / Speedo / "FontPath" / USR / X11R6 / LIB / X11 / FONTS / TYPATH "/ USR / X11R6 / LIB / X11 / FONTS / 75DPI /" FontPath "/ USR / X11R6 / LIB / X11 / FONTS / 100dpi / "EndSection Section" Module "Load" xtt "Load" extmod "Load" glx "Load" dri "Load" dbe "Load" record "Load" xtrap "Load" type1 "Load" speedo "EndSection Section" InputDevice "Identifier "Mouse0" Driver "mouse" option "protocol" "auto" option "emulate3buttons" option "device" "/ dev / sysmouse" option "zaxismap Ping "4 5" endsection Now when you reopen StartX, you will find that your graphical interface has been completed, but you have to change the font. Everything is OK!
