HP UNIX network management

zhaozj2021-02-16  105

File /etc/nsswitch.conf Configuring a domain name resolution method.

Lanscan -a lists the MAC address of the NIC

ioscan -func LAN lists the third layer information

NIC installation

1 Software: Swlist -l Product | More

Need to have NetConfig ... LANLINK software

2 driver

ioscan -func lan

If the network card is displayed as "Unclaimed", use the SAM to generate a driver

KERNEL Configuration -> Drivers

KERNEL Configuration -> Subsystems

3 Reconstruction device files

CD / CDV

INSF-EC LAN

-C Class

-E EXISTING DEVICE

4 reconstruction diagnostic files

CD / DEV

INSF -D DLPI -E

Routing adjustment

Route Add Deflaut 192.6.1.6 1

Route Add Net 192.6.30 192.6.36.3 1

Route Delete Net 192.6.3

Route Add Default 192.6.12.3 1 - Add Default Routing -

Network profile /etc/rc.config.d/netconf

Configure IP addresses to LAN0

IFCONFIG LAN0 192.6.12.34 Netmask 255.255.255.224 UP

View LAN0IP address

Ifconfig lan0

Check IP by Hostname

NSLOOP UP

Hostname

Check the network card MAC address

Lanscan

Test 1-2 layer state

Linkloop Mac_Address

Lanadmin

Manage IP-> MAC mapping

ARP command

View routing table

Netstat -Rn

-A Display All Connections and Listening Port

-N Dot-Decimal Format

-i network interface status

-r routing table

-RS routing statistics

/ etc / networks network address to the name mapping

/ etc / hosts network address to the host name mapping

-------------------------------------------

How to change HP-UX IP?

: Should be changed with SAM, or change the configuration file /etc/rc.config.d/netconf: ifconfig is just a temporary change? When the master is changed, you can use ifconfig to change or change /tc/rc.config .d / netconf. But don't forget to change the / etc / hosts file. If this file is not changed, it will cause the CDE interface to start normally. At the same time, there are other commands such as Swlist swinstall can't use it.

转载请注明原文地址:https://www.9cbs.com/read-11295.html

New Post(0)