1. The call is a call button on one side of the elevator door, partial ↑ or ↓ 两 两. Passengers should select to ↑ or buttons according to their own destination floor, should not be pressed, otherwise it will affect the correct orientation and operation of the elevator, delay time.
When the passenger rushed to the door of the elevator, I just met the elevator was closing. At this time, I don't have to hit the elevator door. I should use the call button to make the elevator to re-open the door, this is the so-called "call" of the elevator " "Features.
2. After the elevator is stopped, you should first let the passengers arriving at this layer, and then enter the car. When the passenger is more than the overload signal (OVER LOAD) flashing and issuing the jelly signal, the elevator has been overloaded, and the passengers entering the car should take the initiative to quit, until the light does not flash, the bell does not ring until.
3. After the selection passengers enters the car, it should be in time to press the slider button you want to go on the manner. The indicator light in the button is light indicating that it has been registered, and the elevator will stop according to the registered floor and open the door.
4. Do not smoke in the elevator car, spit, throw the debris, do not fight, do not damage the elevator facility.
5. The use of the fire switch is used in the call box of the elevator underlayer {base station}, there is a red dial switch with a transparent glass, ie the elevator fire switch. When the fire, the fire, the ambulance person can knock the glass, and turn the fire switch to start the "fire emergency anti-base station" function. The car immediately stops normal operation, quickly return to the base station to open the door.
