ADODC control problem solving

xiaoxiao2021-04-08  372

Solution:

One: Open the properties of AdodC1, will appear interface, then click Build, Figure II interface

Figure 1 attribute of AdodC1

Two: After the interface of Figure II, select the entry shown in the provider, then click Next

Figure II

Then click on the connection, see Figure 3, follow the above mentioned above, then test the connection, there is no error, that is, the test connection is successful.

It can be seen that the ADODC control is finally rooted, huh, huh. . . . .

转载请注明原文地址:https://www.9cbs.com/read-132807.html

New Post(0)