Although the Caiyang II is older, but still wants to play the greatest efficiency, one of its methods is overclocking, but sometimes the motherboard does not jumper, BIOS has no overclocking option, the software overclocking is not convenient, what should I do?
An alternative method is to use a method of shielding the CPU pin. I think this method is not bad. My CPU is Celeron II 667. Default Forevinal 66, after this method, the motherboard is 100 defaults 100, that is, the frequency is 1G.
Let's talk about the specific method: 1. I want to make 66 extraordinary CIIs to 100 files, just use plastic cloth shielding BSEL0 footrests 2, I want to turn the 66 extravagute CII to 133 files, only need Use plastic cloth to shield two pins, 3, want to exceed 100 foreign CIIs to 133 files, only need to use plastic cloth shielding BSEL1 footrests to this two pins, the specific location of the Pin is: DPRK, you can see that there are two lack of missing, and the two lackles are on the left, then the number of pins in the upper right corner, count to the fifth row, === third That is, BSEL0, the fourth is bsel1 === As shown in the figure below: The specific operation is also very simple, remove the CPU from the board, the pin is facing up, determine the pin to shield, find some soft Thin and strong plastic cloth, hard not catching the feet, thick or not, it is easy to be squeezed; cut it into small pieces, specific size, smaller than 指略 甲 甲 到 脚Then, then the needle of the needle, the needle, slowly put the border of the plastic cloth, and then wrap it, and then carefully, make it thoroughly packaged, it can be, in fact, simple say Don't deliberately go to "wrap", just determine "package"! Ok, let's take a seat, everything needs attention to pay attention. If the outer frequency is not changed after booting, enter the CMOS or the original outfit file, explain that there is absolutely no wrapped or wrapped wrong, come back! If there is no light, there are such possible: 1, no wrap or wrapped wrong, only round; 2, the voltage is not enough, pressurized 3, memory can't keep up, clear CMOS; 4, CPU is not qualified, Go, ... In order to prevent white feet, it is best to determine that the CPU to be super, can't do it again.
