Started to complete a bare metal installation

zhaozj2021-02-16  80

I haven't been written in a few days, and I'm ending, about the assembly of the computer.

I can't specifically say something so now, so I have to talk about it in a few days.

The step of the installed, of course, this step is not standard, just in most cases.

It is in this order. Before assembling your computer, you still need to do some preparations before the installation. The first is the tool, you should prepare several tools: screwdriver, sharp pliers, forceps, universal

table. Of course, the screwdriver is essential, with "one" glyph called "flat modulating cone",

One is the "ten" glyph called "plum blossom". Try to use the magnetic screwdriver with magic.

It can reduce the difficulty of installation. Secondly, the computer's accessories are prepared, and the computer should be prepared before assembling the computer.

Accessories to facilitate assembly. Tool accessories are ready, the rest is the installed, it is not right, it is as important

Things to do, that is ------- Release static! The method of releasing static electricity is very simple,

Wash the hand with a large block of ground metal items or wash it with water. Direct method is to touch

Chassis. OK, ready to work, start the machine. Assembling the computer to follow the procedure below. (1) Mounting chassis, power supply (2) Install CPU, fan, where there is something to pay attention to, many people sometimes forget in CPU

A layer of silicone is applied between the fan to enhance the cooling of the CPU. When coating silica gel, don't apply

Too much, too much, it will affect the cooling of the CPU. (3) Install the memory module, this place, as long as you pay attention to the gold finger gap and the main board memory

The position of the slot port is corresponding. (4) Secure the motherboard to the CPU, the fan, and the memory module to the chassis. (5) Install the graphics (6) Install the sound card, now many motherboards have made the sound card on the motherboard, so sometimes

This section can be omitted. (7) Install the drive, the drive refers to the drive, hard disk, and floppy disk. (8) Drive connection (9) Signal control line (10) later finished, finishing data lines inside the chassis, so that the space of the chassis is as possible

More, strengthen heat dissipation capacity.

OK, here, the things in the main chassis are gone, don't forget to be in this place.

Electric self-test, but even if it is done before powering, if you carefully observe if there is a mistake

. The rest is to start the connection, next to the following, the next (11) Install the keyboard, mouse, this place should not be difficult, generally purple

The corresponding keyboard, green correspondence mouse, align the interface, to take a position, don't

Do not stop. (12) Connect the display, the signal line of the display is tightened in the socket of the graphics card,

Yes. The power supply connection problem of the display, some can be directly connected to the main chassis, by the main

The chassis provides power supply, and now you can also get a power supply. If there is a cat, connect one end of the cat's serial data connection to the serial port of the host. When it is here, a bare metal is installed. The rest is to start BIOS settings.

Install the operating system.

转载请注明原文地址:https://www.9cbs.com/read-14789.html

New Post(0)