LILO User Guide (below)
Linuxaid.com.cn
Hubertzou
〖
Back to〗 Forward〗
LILO Usage Guide (below) Hubertzou@linuxaid.com.cn 4. LILO Startup Error Display Analysis <1> When LILO is loaded with itself, the word "lilo" is displayed: Each of the specific procedure shows a letter. If LILO has failed in some place, there are several letters on the screen to indicate where the error occurred. There is a more detailed description in the technical documentation. (Note: LILO is not a program, but a group of programs) Note that if the disk is instantaneous malfunction, some hexadecimal numbers may be inserted after the first letter "L". Unless LILO stops there, there is no serious problem. <2> () LILO is not loaded at all. LILO may not be installed, or the partition is not activated. <3> L ... LILO's first part has been loaded and running, but it cannot be loaded into the second part of the boot program. The two-digit error code indicates the type of problem (see later " Disk error code "). This is usually not matched in media access failure or hard disk geometry (CHS, CHS). The first phase of Li Lilo has been loaded into the second part of LILO, but does it fail. The reason is that the hard disk geometric parameter does not match or /boot/boot.b has not re-running mapping (MAP) installation program. The second phase of the LIL has been launched, but it cannot read the descriptor table from the Map file (the Descriptor Table) is the medium error or the hard disk geometry does not match. The second part of the LIL? LILO is loaded into the wrong address. Typical reason is that hard disk geometric parameters are subtle or /boot/boot.b move without running a mapping installer. The LIL-descriptor table is destroyed. This may be that the / boot / map is not running the mapping installer or geometric parameter does not match. All parts of LILO LILO are successfully loaded. 1010101010 The partition has changed until reinstalling LILO, it is said that overclocking will also come. Disk error code: 0x00 "Internal Error". Generated from the LILO sector reading subroutine. It may be a crucial file to rebuild the Map file. Another reason is perhaps when using the linear parameter to access the cylindrical plane exceeding 1024. 0x01 "illegal order". It should not happen, if it appears, means lilo to visit the hard drive that the BIOS does not support. When I organized this document, I met the mist to the L010101 ..., because he put Linux on the second IDE port (/ dev / hdc), plus the Disk parameter. 0x02 "Did not find address tag". Usually a media problem, try a few times. 0x03 "Write protection". The appearance is only when the write operation is written. 0x04 "Sector is not found". Typical causes is that the hard disk parameters do not match. 0x06 "Activation Sequence Change". This should be a short error, try again. 0x07 "invalid initialization". BIOS is not properly initialized, and the hot start may be helpful. 0x08 "DMA beyond limit". This should not occur, restart. 0x09 "DMA is trying to cross the 64K boundary". This should not occur, it is recommended to ignore the Compact parameter. 0x0c "invalid media". This should not happen, restart to see. 0x10 "CRC Error". The medium error was detected. It is recommended to start a few times, run the MAP installer, write the MAP file from the bad block to normal media. 0x11 "ECC correction success".
