Realtek Help8139 Ver 1.10
========== start of file ========== Microsoft Network Client 3.0 for MS-DOS Introduction: ------------- This Document Describes the Procedure to setup The Microsoft Network Client for Dos Driver on realtek RTL8139 Fast PCI Adapter. location of driver: /ndis2dos/rtsnd.dos Sample Configuration FILES: ------------------- -------- EX1: [Protocol.ini] (Install Creates this file) [Network.setup] version = 0x3110 netcard = RTL8139,1, RTL8139,1 transport = ms $ ndishlp, MS $ NDISHLP transport = ms $ netbeui, MS $ NETBEUI lana0 = RTL8139,1, ms $ netbeui lana1 = RTL8139,1, MS $ ndishlp
[Protman] Drivername = protman $ priority = ms $ ndishlp [ms $ ndishlp] drivername = ndishlp $ bindings = RTL8139
[MS $ Netbeui] drivername = NetBeui $ sessions = 10 ncbs = 12 bindings = r r =8139 lanabase = 0
[RTL8139]; RTL8139 RPOTOCOL.INI SAMPLE DriverName = RTSND $ EtherID = @ 52544C111111; This keyword is used to desinate a RTL8139; adapter by assigning its ethernet ID; when more than one adapters exist on one; system.
Busno = @ 00; this keyword is buy to desinate a rtl8139; adapter by assigning it's pci bus number; When More Than One Adapters Exist on One; System. (Must Be used with 'DeviceNo' keyword)
Deviceno = @ 0A; this keyword is buy to desinate a rtl8139; adapter by assigning it's pci device number; when moreward adapters exist on one; system. (Must BE Used with 'Busno' Keyword)
Medium = 100/10; this keyword is used to force r...........................
Installation Procedure: ---------------------- Before you start with the installation procedure, make sure that the adapter isotly installed and configured. Similarly, Make Sure That Your Microsoft Network Client is properly installed. (If not, The installation utility SETUP.EXE is located on Microsoft Network Client v3.0 for MS-DOS Disk. Run SETUP.EXE from Disk and the SETUP program screen will appear, and You must complete each of the questions. These options are specific to your needs. The installation procedure will transfer files to a specific directory on the client and modify existing configuration files to fit your specific needs.) 1. Change to the Microsoft Network Client subdirectory, and run Setup.exe
2. The Screen Will Display Some Infomation. Press
Installation Procedure: ---------------------- Before you start with the installation procedure, make sure that the adapter isotly installed and configured. Similarly, Make Sure That Your Microsoft Network Client is properly installed. (If not, The installation utility SETUP.EXE is located on Microsoft Network Client v3.0 for MS-DOS Disk. Run SETUP.EXE from Disk and the SETUP program screen will appear, and You must complete each of the questions. These options are specific to your needs. The installation procedure will transfer files to a specific directory on the client and modify existing configuration files to fit your specific needs.)
1. Change to the Microsoft Network Client Subdirectory, And Run Setup.exe2. The Screen Will Display Some Infomation. Press
3. Responds to the screen Prompts, Selecting "Change Network Configuration", THEN PRESS
4. Move The Highlight to "Add Adapter", Press
5. SELECT "NetWork Adapter Not Shown On List Below ...".
6. Insert The Realtek RTL8139 Driver Diskette IN Floppy A, And Specify Your Pathname A: / Ndis2dos, Then Press
7. Follow screen instructions to complete the process. Simply pressing
- jack chen -
========== End of file ==========
