How to use a double WAN port TL-R480 Internet cafe router with a Double WAN-gate design, but there are many questions about how to use such equipment, users have a lot of questions in this router, WAN port Online detection, flow equalization control, etc., make a detailed introduction. First, the WAN port is set, for example, in a environment with two lines, a 10m fiber optic line, a 2M ADSL line. The fiber optic line uses a static IP setting, after selecting the WAN port 1 sets the IP address, after the DNS server, please note the download bandwidth settings below the page, please fill in the relevant parameters, as shown in Figure 1 below.
figure 1
ADSL line selection WAN port 2, connection type selection PPPoE, then fill in the authentication user name and password provided by the ISP. The connection mode can be selected as needed. Then enter the advanced setting below the page, fill in the user's local DNS server address, and fill the download bandwidth and upload bandwidth value. as shown in picture 2.
figure 2
Tip 1: Fill in, download bandwidth is very important to implement the bandwidth of the line. If the cable flow is not filled in the corresponding bandwidth, the line traffic is allocated, as in the case mentioned in the case, when the user downloads traffic exceeds 4m, the line 2 will overload the overload, causing some users to connect or drop the line. . Second, WAN Oral Online Detection This project is set as follows: 1. Ping's target IP is as far as possible to the gateway of the WAN port, such as the WAN gate gateway that appears in the router Run, if the gateway It is not ping that selects a DNS IP that can be PIN. 2, the request IP of DNS should be set to the actual DNS of the WAN port, such as DNS202.96.134.133 of Shenzhen Telecom. If the PING Target IP is used, the DNS IP is used, then it should be set to the alternate DNS IP. 3. Try to avoid the same situation like the PING target IP and DNS request IP, because once the IP corresponds to the server, the corresponding WAN port of the router will be automatically disabled! Tip 2: Online detection can make the correct judgment on the line connection, if no settings are not set, the discovery of the disconnection will be slow, resulting in some connection abnormal connection in the network, such as opening some web failed. WAN Oral Online Detection Settings See Figure 3.
image 3
Third, flow equalization control For users who use special resources in the line to enable traffic equalization control, such as two lines provide different special movies, game access. In order to better apply such resources, you can enable accessories IP address scheduling rules in traffic equalization control. If there is a file server provided in the line 1, the IP address is 218.125.10.10. There is a game server provided in the line 2, and the IP address is 202.96.134.168, two scheduling rules are added to the flow equalization control. And pay attention to the enabled, make it effective, as shown in Figure 4.
Figure 4
