The author is actually familiar with FW, but writes down a little experience summed up in the application process, I hope to use the beginner, and also ask the high finger.
In the drawing design, what we usually do is to handle some characters or things from the picture from the picture. In FW, despite the "polygonal set tool", it is not ideal, it is not ideal, and the main lack of: 1, can only be used as a polygonal set, and the arc edge cannot be precisely checked. 2. In the case of checking, it is not possible to refund, that is, when the previous check is not ideal, it cannot be returned, only the entire re-checking. The author found that FW Zhongfan is a vector graphic can be machined as a mask to process other pictures. After practical and summarizing, a graphic check method that can better solve the lack of "polygonal set tool".
Specific steps: 1, use the pen tool to define several key points, substantially outline a contour, these key points don't need too accurate, because these points can also be appropriately deleted in future operations. The red dot and the line of the next picture are the outline of the steel pen tool.
2. Use the pen tool again to operate the key points, drag the adjustment handle of each point.
3. Adjust the adjustment handle to make its lines with the contour of the hook. However, it will be described here that if we only use the pen tool to adjust, you will change the lines of the lines, if I just want to adjust while adjusting, I need to use "Partial Selection Tool" ( The hollow arrow). After selecting "Partial Selection Tool", put the mouse on the adjustment point of the adjustment handle, and press the Alt key, you can adjust one of them.
4, after the check is complete, all the pictures you want to check and use the path generated by the pen, then click "Modify-Montage-Combination Map" on the menu bar. A single picture will be checked out.
4, after the combination is the mask, the actual situation is that the original image still exists, but because of the role of the mask, we have seen the part of being checked. If we do just want to take a further handling, then We can click "Modify-Place Selected" on the menu in turn.
At this point, the selection process of the picture is complete, and it can be placed further after copying it. BTW, the operation in Photoshop is similar to this article. If you are accustomed to using PS, you can also refer to this article. If you have any mistakes, please refer to.
