1. About this article 1. First of all, thank the Bitcomet development group to provide us with such a high-performance BT download client software. 2. If you increase the download speed with this help, please do not limit the upload speed during download. 3. This article is suitable for improving friends who have not reached their own network download limit. (For example, you are 512K want to increase the speed from 64kb / s to 128kb / s, then please don't look, directly put your own bandwidth Width is). 4. Before using BC, it is recommended that you optimize your own network and optimize the software THROTTLE. Second, Bitcomet settings: (unnotable parameters, keep the original set value unchanged) 1. Run BitComet 0.56, open your own BitComet's "Option" column, click on the "Network Connection" global maximum download speed Unlimited adjustment to 1000 (2M below user 1000 is an unreachable number, so feasible). The global maximum upload speed is not restricted to 40 (depending on the personal situation reasonable choice, this is my suggestion). The listening port is recommended not to repeat with 6881-6889 16881-16889, and the personal feeling between 19770-22000 is better. (Of course, you map the port, then you will be subject to the listening port you map, you don't need to change), the user who installed the firewall opens your monitor port in your firewall. 2. Click Task Settings. The parameters inside this are temporarily unchanged. In the later adjusted, "maximum upload speed per task" is required. 3. Click on the interface to display the number of peers to 10004. Click Advanced Settings If you can't connect within a minute, add an alternate TRACKER: 30 30 to 0 Alternate Tracker list 5. Click on the network connection Each task per task: change to 1000. Keep the connection per task: Change to 50. Global guarantee the number of uploads: change to 10. Connection initiation interval: change to 150 or 100. Maximum attempt to TCP connection number: change to 1000. Whether it is allowed to implement an intranet interconnection via UDP: Internal Network Settings "Allow" public network setting "prohibition". 6. Click the IP rule to download the task Each IP maximum allowable connection: Change 20 Upload task Each IP maximum allowable connection: User to 5 internal network "Allow to report the intranet IP to the subnet connection" 7. Click Disk Cache 256M Memory Configuration Disk Cache Minimum: 6M Disk Cache Maximum: 30M Decrease Disk Cache When the free physical memory is lower than: 50M automatically adjusts the cache on the maximum minimum range. Third, the parameter adjustment of the download process first talks about the hot seed: 1. After the above settings, please download a popular seed (the number of seeds exceeds 20, the number of users is more than 200), starting this separately. 2. When downloading, you can see the connection, the user is increasing, the upload download speed is slow, the equal speed reaches 1/2 of the normal download speed of you usually, the number of connections is greater than 50, and the seeds are more than 1 time (about 5 -10 minutes), click on "Task Settings" to change the "maximum upload speed per task" to 10-20, continue to download. 3. After 2 minutes, if your speed is getting up, and you will be relatively stable, please keep it. If your speed is not up, you can use the following two ways: a. Continue to transfer each task with the speed of 2K; BA does not mean that your adjustment time is wrong, put "maximum upload speed per task" Restore it to "Unlimited" During the time. Cold door cooler seeds may not have a lot when you tap "maximum upload speed per task", if you have effect, please keep it. No effect, do not set "maximum upload speed per task" or set high points such as 25-30. Note: 1. I want to know that I am the intranet or the external network. I'm looking at my own IP, 10.x.x.x, 192.168.x.x is the intranet, and it is not seen that the remote is also the intranet.
