Http://tech.sina.com.cn/c/2002-06-25/14051.html
Deep: Lift Linux, deep has been very concerned about it, like Sun, IBM's large companies are promoting Linux. Not long ago, many of the Zhongguancun Electronics Market pre-installed Linux. However, in the home market, Linux's competitiveness is not very ideal. Here's this article describes how to get online in Linux. If you use Linux, you can refer to it.
When I was using the red flag Linux 2.0 desktop system, I suddenly discovered a problem. I used the Ethernet broadband (the type of 5 categories of lines to the house), but I don't know how to get online under Linux. I found some information, I found that both ADSL or Ethernet broadband, all based on PPPoE protocol virtual dials. So I think, if PPPoe is installed under Linux, it should be available. After test, I finally successfully internet, and this method is also suitable for various Linux operating systems. I will share it with you.
Here, you have installed your network card. If you are still uncertain, use the "ifconfig eth0" command to see. In the network setting, the IP address should be played, it is best not to set the address to make it empty. Then set the DNS, routing what is empty.
Install the PPPoE package
First, please download http://www.roaringpenguin.com/pppoe/rp-pppoe-3.4-1.i386.rpm this package. You can download it first in Windows, then load it into the partition under Linux with the mount command, but the red flag's Linux will load automatically, as long as you open the root / mnt directory, there is all the files on the hard disk, naturally include Under Windows. Then it is installed. If you are in X-windows, click the icon of this file, it will be installed, it is installed, it is very convenient. If it is in the character interface, please type: rpm -uvh rp-pppoe-3.2-1.i386.rpm on the directory where the package is located.
Set a dial program
This must be on the character interface, type ADSL-SETUP, and type as follows.
Enter Your PPPoe User Name: Enter your username of your broadband account.
Enter the Ethernet Interface Connected to the ADSL MODEM
For Solaris, this is Likey to Be Something Like / DEV / HME0.
For Linux, IT Will Be Ethn, Swherees'n 'Is A Number.
(Default Eth0): This is the name of the NIC card you enter, usually choose the default (press Enter).
Enter the demand value: Type "NO"
Enter The DNS Information Here: Enter the DNS server address, which means that the Broadband Service Provider will automatically provide you with the DNS server IP address.
Please enter your pppoe password: Enter the password of the broadband account.
Please confirm your pppoe password: Enter the password that just broadband account again.
Choose a type of firewall (0-2): Enter 0, indicating that the firewall is not used.
ACCEPT THESE SETTINGS AND Adjust configuration files (y / n)? If the information you entered correctly, enter Y, complete the configuration, otherwise enter N reset. online
So much, I finally arrived, I can type in the character state: "ADSL-START", Linux will automatically dial the Internet. Type: "ADSL-STOP" when you are disconnected. Everyone now knows how to dial on Linux down, don't download a try!
