The brushes can be made according to the need to decorate, made into straight grain, chaos, threads, corrugations and rods. Direct grain drawing refers to a method of processing a straight lines in a mechanical friction in the surface of the aluminum plate. It has a double effect on the surface of the aluminum plate surface and the surface of the decorative aluminum plate. Direct grain wire has two kinds of continuous filament and intermittent filament. Continuous filament can be obtained by continuously horizontal linear friction of the aluminum plate surface (such as manual mobrah or holding wire brush on the aluminum plate on the aluminum plate under the condition of the existing device). Change the diameter of the steel wire of the stainless steel brush to obtain different thickness of the ripple. Intermittent filament is generally processed on a brush machine or wicker. Principles: The two sets of rotating differential wheels are used, and the rapid rotating grinding rolls are subjected to a rapid rotating grinding roll, and the aluminum or aluminum alloy plate is passed from the two sets of roller, and brushed out Delicate and intermittent straight grain. The ripple brushed wire is a random rigid, a matted ribbon that is obtained from the aluminum plate, and there is no obvious ripples, and there is no obvious pattern. This processing is high on the surface requirements of aluminum or aluminum alloy plates. Corrugate is generally prepared on a brush machine or wicker. Using the axial movement of the upper part of the grinding roller, the surface of the aluminum or aluminum alloy sheet is ground to draw the wavy lines. The rotary wire is also known as the rotation of the cylindrical felt or the Ranni Niger wheel, and the aluminum or aluminum alloy plate surface is used to rotate the surface of the aluminum or aluminum alloy plate. It is used for decorative processing of circular signs and small decorative dials. The threaded brushed wire is a small motor with a circular felt on the shaft, which is fixed on the desktop, along with the edge of about 60 degrees, and makes a towboard with fixed aluminum compression tea, on the drag The polyester thin film that is stuck on the edge is used to limit the threads. Using the felt rotation with the straight line of the drag, the threaded lines consistent with the width of the aluminum plate surface are screwed.
Reserved part of the rights Hillinsilence to retain part of the rights in this paper, the remaining part of the copyright and ownership is reserved by its owner.
