First let's take a look at the tools used, these are actually very common, you can use hair glue, you can also use the use of 水, what is the characteristics of these tools that are used to do hairstyle? These two hairdresses have a strong viscosity, sprayed as liquid, and when it is half or full, the viscosity is the largest.
The specific operation step first pops up the light-driven door before the system is shut down, and then shut down the power cord, insert the hair glue or water inside the optical drive, pay attention to the direction of the spray, and can focus on the two parts. The first is the optical drive lead portion, and the other is the optical drive motor and the part of the drive gear and the rubber band.
The purpose of our operation is to achieve is:
There is a problem with a lens that enables a focus. The optical drive is composed of a laser emission, a feedater, and a focus lens. We can form a film on the lens in the optical drive, so that the laser focus is not accurate, this optical drive reads capability It will be greatly dropped, and the optical drive during the warranty period is driven to be replaced there in JS.
The second object is to cause the optical drive transmission to be damaged, the rubber band and the gear and the rubber band are bonded together, resulting in the warehouse door that cannot be fully popped up, the appearance is completely mechanical failure, we also reach the hardware purpose.
So what will the optical drive will happen? Situation 1. Emergencation of the optical drive reading capacity, even if the newly purchased genuine disc can not read smoothly, the case 2, due to the injection of the bald head, the symptoms of the photographed are in the optical drive It is discharged immediately and cannot be read. Situation 3. The damage of the transmission makes the optical drive warehouse after the power-on cannot be popped up. I believe every point in this is a powerful exchange condition. Since the optical drive has a warranty label in a key part to prevent the user from opening the optical drive housing itself, the method described above has become the most simple and effective destruction method. Through the methods described above, there can be a variety of other methods, such as using banana water to irradiate the gear rubber band, use conductive silver paint to make the drive motor positive and short circuits, etc.
Optical drive alternative destruction method:
First we have to understand how the CD is turning in the optical drive. When the warehouse is closed, the disc circon heart is covered by the upper and lower pulleys, turns through the motor operation, after pressing the warehouse, the following pulley downward Move, then the tray outward. What we have to do is not letting the tray pop up, you can complete the purpose of destroying the optical drive. The tool only needs to be scrapped, 502 glue a bottle, then use 502 glue to apply the pulley bonding in the optical disk, and then quickly put the tray with the disc in the optical drive, so after a few minutes, when the disc is up and down When the two pulleys are dead, the optical drive tray will no longer have. This method is suitable for warranty with JS. If the maintenance center is replaced, the maintenance personnel may open the optical drive housing for inspection, so there is a possibility that it is identified.
