The American DB102-C users can not be missed - the continuing DB102-C (White version) Olda DB102-C users can not miss the US - continuing DB102-C (White Edition)
Route Method for Setting Shanghai DB102-C - type ADSL Cat:
1. Use the toothpick to continue the small hole on the back of the back three times to restore the factory default settings.
2, the machine network card gateway is set to the default gateway of the cat: 192.168.1.1, the IP address is: 192.168.1.? , "?" = 2 ~ 254, restart the PC and make the network cable and plug it, the purpose is to let the NIC will re-obtain the IP address.
3. In the browser http://192.168.1.1, enter, enter your username: admin, password: Dare
4. The original one is also deleted in the "PPP" setting of "WAN". Show: No PPP Interface Entry!
5. Look at the VCI that the telecommunications is given to you in "ATM VCC" in "WAN". The VPI parameter is AAL5-? My VCI, VPI = 8, 35, is AAL5-4.
6. Add in the POP in "WAN", configure in the pop-up window: interface: PPP-0, IPF type: public, underlying interface: AAL5-3, Status: Start, Protocol: PPPoE, use DHCP: Disable Using DNS: Enable, default routing: enable, write your virtual dial username and password, press "Submit".
7. To ensure constant flow, point management page -> port settings, the HTTP and TELENT values are set between 61000 and 62000,> Submit.
8, point management page -> Save & Restart -> Save -> Waiting for Successful. Restart MODEM.
9, then delete the gateway of the network card, the IP address is automatically, disabled DNS, restart the PC and MODEM, and diaryl the network cable and plug it, the purpose is to let the NIC re-acquire IP address.
10, open IE, OK!
Built-in dial and route of DB102-B and DB102-C! First of all, we must know the "VPI", "VCI" of the ADSL, "VCI" value; assuming 8, 35 first resetting your cat, then enters the cat's settings by http://192.168.1.1: Click " Bridge configuration "This topic related pictures are as follows: Delete the useless interfaces, leaving only interface" Eth-0 "and" EOA-4 "because" EOA-4 "corresponds to" VPI "" VCI "8,35 Figure: This topic related pictures are as follows: Click "EOA Settings" and delete those useless interfaces, leaving only interface "EOA-4" and then save; then click "ATM VCC" to delete those interfaces that are useless, leaving only The next interface "AAL5-4" is then saved and then click "PPP Settings" and click "Add" to fill in the following picture. This topic related pictures are as follows: and then save, restart.
At this time, "Cat" is "routing and bridging" If the cat is only doing the "routing" state, you are as follows: Click "Bridge Configuration" and click "Enable / Disable" as shown below, and finally save restart . The related pictures of this topic are as follows:
