When using Ghost et al, many friends have found a cloning hard disk that there is no OpenServer operating system, and there is often a post on the screen. There is often a post on the screen. The reason is that the boot module of the OpenServer operating system excessively relies on the geometric parameters of the hard disk, and if the SCO partition starting position on the cloned hard disk is: Cylinder, the sector number, the sector number, and the source disk. Then OpenServer can be properly guided, otherwise "NO OS" will be prompted by the partition of the SCO. Solution: 1, 5.0.6A / 5.0.7 Source Distribution: According to some foreign SCO Forum Post, SCO solves this problem for the "WD Driver Supplement" patch released by 5.0.6a / 5.0.7, before cloning Install this patch software on the source disk, then clone it should be able to solve the problem of cloning hard disk NO OS, even if the hard disk geometric parameters are different, the boot module after installing the WD patch can also be automatically corrected by the actual parameters to correctly boot.
